Shop fox W1872 Owner's Manual page 18

6. Remove flex-shaft cap shown in Figure.12.
7. Insert inner spindle of flex-shaft into threaded shaft
in saw, then turn flex-shaft clockwise to tighten, as
shown in Figure.13.
8. Insert included drill bit or a tool bit (not included)
into flex-shaft collet.
9. Insert collet locking pin into hole on collet and
tighten bit with 9mm flat wrench by turning
clockwise, as shown in Figure.14.
Model W1872 (For Machines Mfd. Since 04/19)
Figure.12. Flex-shaft cap location.
Figure.13. Example flex-shaft installation.
Drill Bit
Figure.14. Securing drill bit in flex-shaft
-16-
Flex-Shaft Cap
Threaded
Shaft
Flex-Shaft
Inner Spindle
Collet
Collet
Locking
Pin
9MM Flat Wrench
collet.