Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 2 – INSTALLATION
2.10.3 Electrical Power Panel Internal Components
Remove the front panel to access the Power Panel. Run the electrical service through the
opening above the Power Panel and make the connections to the Power Breaker in accordance
to the Power Panel cover label (see Figure 2-9, above).
WARNING!
The power breaker, shown in Figure 2-10a and 2-10b does NOT remove power from the
terminal blocks.
12V POWER SUPPLY
Figure 2-10a: BMK750 - 1500 110 V Power Panel
•
GF-210 •
OMM-136_H
WIRE CONDUITS
FUSE BLOCK
FLAME ROD SIGNAL
AMPLIFIER
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
1/6/2021
FUSE BLOCK
TERMINAL BLOCKS
POWER
BREAKER
Page 35 of 62