Table of Contents
Advertisement
Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 3 – ONAER SETUP
2. Once enabled, the following additions parameters appear:
Unit Upload Time: Determines how frequently unit data will upload to the server, in
•
seconds. This will be split between unit data and cascade data (Manager unit only).
(Range: 30 to 9999)
Cascade Upload Time: Determines how cascade data will upload to the server, in
•
seconds. (Range: 60 to 9999)
Status: Displays the communication interface status, which varies depending on the
•
interface selected in Step 2.
3.1.1 Connecting the Ethernet Cable
Connecting the Ethernet Cable Instructions
1. Connect a CAT 5 or better Ethernet cable to the wall jack or box provided at the site.
2. Route the Ethernet cable to the left side of the Edge Controller, avoiding hot locations.
3. Plug the Ethernet cable into the Edge Controller's Ethernet jack (see Figure 3-1).
ETHERNET
JACK
Figure 3-2: Edge Controller – Left Side View
•
GF-210 •
OMM-136_H
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
1/6/2021
Page 48 of 62
Advertisement
Table of Contents
