Table of Contents
Advertisement
N.B.:
• Avoid bending the drain pipe too much in order to prevent clogging.
Outdoor unit installation
Step one: secure the outdoor unit support
1. Choose a location for the unit according to the structure of the house.
2. Use expansion screws to secure the outdoor unit support in the chosen position.
N.B.:
•
Take the appropriate safety measures when
installing the outdoor unit.
•
Make sure that the bracket can support at
least four times the weight of the unit.
•
The outdoor unit must be connected at least
3 cm above the ground in order to install the
drain joint.
• Units with a cooling capacity of 2300 W
5000 W require 6 expansion screws; units with
a cooling capacity of 6000 W – 8000 W require
8 expansion screws; units with a cooling
capacity of 10000 W – 16000 W require 10
expansion screws.
Step two: install the drain joint
1. Connect the outdoor drain joint into the hole
on the chassis, as shown below.
2. Connect the drain hose into the drain hole.
foro di
scarico
tubo di scarico
foro di scarico
tubo di scarico
chassis
giunto di scaricoesterno
foripiedini
Step four: connect the indoor and outdoor pipes
1. Remove the screw on the right-hand handle
of the outdoor unit and remove the handle.
vite
impugnatura
V 11/15
chassis
giunto di
scarico esterno
vite
impugnatura
screw
handle
–
at least 3 cm above the ground
Step three: secure the outdoor unit
1. Position the outdoor unit on the support.
2. Secure the foot holes of the outdoor unit with
bolts.
drain hole
drain pipe
chassis
outdoor drain joint
foot holes
3. Pre-tighten the union nut by hand.
giunto tubo
dado raccordo
giuntotubo
dado raccordo
fori piedini
fori piedini
pipe joint
union nut
24
Advertisement
Table of Contents
