Table of Contents
Advertisement
1. ON/OFF button
Press the ON/OFF button to turn the air conditioner on or off. When you turn on the air
conditioner, the power indicator
The colour varies for different models. The indoor unit will emit a beep.
2-3. ▲/ ▼ button
Press "▲" or "▼" once to increase or decrease the set temperature by 1°C. Press and hold
"▲" or "▼" for 2 seconds to rapidly adjust the set temperature on the remote control. When
set-up is complete, release the button and the indoor unit's temperature indicator will change
accordingly. (The temperature cannot be adjusted in automatic mode).
When setting the TIMER ON, TIMER OFF or CLOCK, press "▲" or "▼" to adjust the time.
(Please refer to the relevant sections for the CLOCK, TIMER ON and TIMER OFF buttons).
4. MODE button
Press this button to select the desired operating mode.
AUTO
COOL
DRY
FAN
HEAT
• When you select automatic mode, the air conditioner will operate automatically according to the
factory settings. The set temperature cannot be adjusted and will not be displayed. Pressing the
"FAN" button will allow you to adjust the fan speed. Pressing the "SWING" button will allow you
to adjust the angle of airflow.
• When you select cool mode, the air conditioner will run in cool mode. The indicator will
illuminate on the display. Press "▲" or "▼" to adjust the set temperature. Press the "FAN"
button to adjust the fan speed. Pressing the "SWING" button will allow you to adjust the angle of
airflow.
• When you select dry mode, the air conditioner will run at low speed in dry mode. The
indicator will illuminate on the display. The fan speed cannot be adjusted in this mode. Pressing
the "SWING" button will allow you to adjust the angle of airflow.
• When you select fan mode, the air conditioner will operate only the fan, blowing air without
cooling or heating. All the indicators will switch off. Press the "FAN" button to adjust the fan
speed. Pressing the "SWING" button will allow you to adjust the angle of airflow.
• When you select heat mode, the air conditioner will run in heat mode. The
illuminate on the display. Press "▲" or "▼" to adjust the set temperature. Press the "FAN"
button to adjust the fan speed. Pressing the "SWING" button will allow you to adjust the angle of
airflow.
N.B.:
To prevent blasts of cold air from being blown into the room, there will be a delay of 1 – 5
minutes after selecting heat mode before operation begins. (The actual delay will depend on
the indoor ambient temperature).
The temperature can be set between 16 – 30°C and four fan speeds are available: automatic,
low, medium and high.
V 11/15
on the indoor unit's display will illuminate (green).
AUTO
COOL
DRY
FAN
HEAT
indicator will
7
Advertisement
Table of Contents
