SAFETY INSTRUCTIONS General • Before switching on and operating the system, first read this safety advice and the operating instructions� • Keep the operating instructions in a safe place for later use� • Installation, commissioning and maintenance of the system may only be carried out by authorised individu- als and in accordance with the installation instructions - ensuring that all applicable standards and guidelines are followed�...
Page 6
WEEE (Waste Electronical & Electronic Equipment) Correct Disposal of This Product (Applicable in the European Union and other European countries with separate collection systems)� This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life�...
PRIOR TO USE • Install the mount onto a strong structure such as concrete wall • Use the supplied accessories when installing the mount bracket depends on mounting position Dimensions (in mm) & Specifications Construction: Plastic Cast (PC + 10% Glass Fabric) Dimensions(mm): 149,00 x 140,50 x 66,90 Weight:...
INSTALLATION Wall Mounting 1� Attach the mounting template to the installation position and drill into the wall� 2� Hammer the 4 expansion screws into the drilled wall holes� 3� Feed the power and BNC cables through the box� 4� Secure the box to the wall with the four screws� 5�...
Ceiling Mounting 1� Attach the mounting template to the installation position and drill into the ceiling� 2� Then mount the box on the ceiling by following the steps 2-9 for wall mounting� Pillar Mounting 1� Install Pillar bracket on a pillar� 2�...
Ceiling Mounting add screw post Mounting Holes not needed Use these holes for mounting the Mounting the INB-5xx / INB-6xx Bullet Camera Base diameter: Ø 84,00 mm Use these holes for mounting the Mounting the INB-7xx Bullet Camera Base diameter: Ø 108 mm...
SICHERHEITSHINWEISE Allgemein • Bevor Sie das System anschließen und in Betrieb nehmen, lesen Sie zuerst diese Sicherheitshinweise und die Betriebsanleitung� • Bewahren Sie die Betriebsanleitung sorgfältig zur späteren Verwendung auf� • Montage, Inbetriebnahme und Wartung des Systems darf nur durch dafür autorisierte Personen vorgenom- men und entsprechend den Installationsanweisungen - unter Beachtung aller mitgeltenden Normen und Richtlinien - durchgeführt werden�...
Page 16
WEEE-Richtlinie (Elektro- und Elektronik-Altgeräte) Ordnungsgemäße Entsorgung dieses Produkts (Gilt für die Europäische Union und die anderen Europäischen Länder mit getrennten Sammelsystemen) Dieses am Produkt oder in seiner Dokumentation gezeigte Symbol bedeutet, dass es am Ende seiner Lebensdauer nicht mit dem Hausmüll entsorgt werden darf� Um eventuelle Umwelt- oder Gesund- heitsschäden durch unkontrollierte Abfallbeseitigung zu verhindern, dieses Gerät von anderen Ab- fallarten trennen und ordnungsgemäß...
VOR DEM GEBRAUCH • Die Anschlussbox an einer tragfähigen Struktur wie z� B� einer Betonwand befestigen� • Verwenden Sie bei der Montage der Halterung je nach Montageposition das mitgelief- erte Zubehör� Abmessungen (in mm) & Spezifikationen Ausführung: Kunststoffguss (KG + 10% Fiberglas) Abmessungen(mm): 149,00 x 140,50 x 66,90 Gewicht:...
INSTALLATION Wandmontage 1� Bringen Sie die Montageschablone an der Einbauposition an und bohren Sie in die Wand� 2� Hämmern Sie die 4 Dübel in die gebohrten Wandlöcher� 3� Führen Sie die Strom- und BNC-Kabel durch die Box� 4� Befestigen Sie die Box mit den vier Schrauben an der Wand� 5�...
Deckenmontage 1� Bringen Sie die Montageschablone an der Einbauposition an und bohren Sie in die Decke� 2� Montieren Sie dann die Box an der Decke indem Sie den Arbeitsschritten 2-9 für die Wandmontage folgen� Mastmontage 1� Installieren Sie die Masthalterung an einem Pfosten� 2�...
Deckenmontage Gehäusestift einsetzen Montagelöcher wird nicht benötigt Verwenden Sie diese Löcher für die Montage der INB-5xx / INB-6xx Bullet-Kamera Basisdurchmesser: Ø 84,00 mm Verwenden Sie diese Löcher für die Montage der INB-7xx Bullet-Kamera Basisdurchmesser: Ø 108 mm...
Page 22
Videor E. Hartig GmbH Exclusive distribution through specialised trade channels only. Videor E. Hartig GmbH Carl-Zeiss-Straße 8 63322 Rödermark / Germany Tel. +49 (0) 6074 / 888-0 Technical changes reserved Fax +49 (0) 6074 / 888-100 www.videor.com...
Need help?
Do you have a question about the AK-20 and is the answer not in the manual?
Questions and answers