Roland V-Drums TD-3 Owner's Manual page 51

1.
Hold down [LEVEL/PAN] and press [TEMPO].
[EDIT] flashes.
2.
Hit the pad you wish to set.
The trigger indicator for the struck pad lights.
3.
Press [+] or [-] to select the trigger type.
Pad
PD-8
PD-6, PD-7, PD-9
PD-80, PD-80R, PD-85
PD-100, PD-105
PD-120, PD-125
KD-7, KD-8
KD-80, KD-85, KD-120
CY-8
CY-6, CY-12R/C, CY-12H, CY-14C, CY-15R
RT-7K
RT-5S
RT-3T
* The RT-7K, RT-5S, and RT-3T are Roland acoustic drum triggers.
4. Repeat Steps 2–3 to set the trigger type for each pad.
This setting applies to both the head and rim.
5.
Strike the pads and press the pedals to check the following.
• Are sounds being played with all pads and pedals?
• Is the right instrument for each pad being played?
If the correct sound is not being played, check the pad settings once more and refer to "Troubleshooting"
(p. 65).
6.
To make other settings, press [EDIT] to select another trigger parameter.
7.
When you're finished, press [DRUM KIT]; the [EDIT] light goes off.
Do not turn off the power without the [EDIT] light having gone out. Otherwise you will lose
the changes you have just made.
The "Xtalk Cancel" (Crosstalk Cancel) value does not change when the trigger type is
changed. Adjust this as necessary in accordance with the pad you are using and the playing
conditions (p. 57).
Value (Display)
Pad and Trigger Settings
51