Dell EMC PowerEdge MX7000 Field Service Manual page 42

Next steps
1. Replace the right control panel
Removing the left control panel module
Prerequisites
NOTE: Before working on the left control panel module, ensure to remove the sled or sled blank from bay 1.
Steps
1. Loosen the captive screws securing the left control panel to the chassis.
2. Move the module partially from the chassis.
3. Open the cable retainer to access the left control panel cable.
4. Disconnect the left control panel cable from the connector on the panel.
Figure 43. Removing the left control panel
5. Remove the left control panel from the enclosure.
Installing the left control panel module
Prerequisites
NOTE: Before working on the left control panel module, ensure to remove the sled or sled blank from bay 1.
Steps
1. Connect the cable to the connector on the left control panel.
2. Close and lock the cable retainer to secure the cable to the control panel.
3. Insert the module into the chassis.
4. Tighten the captive screws to secure the control panel to the chassis.
42 Field service information
ear.