Advertisement
www.aeroplusrc.com
Using the pushrod supplied screw ball joints onto each end. The correct length will leave the aileron lined up to the inner part still attached to the
wing.
Using supplied bolts attach the pushrod at both ends. Check to see you have sufficient movement of the aileron. If not adjust.
Carry out the same procedure on the other wing.
Electric
Using the lines on the firewall, mark using your mount as a guide. Then drill suitable holes.
Depending on the length of your motor you may need to use the supplied round plywood spacers to achieve the correct length for the motor.
Mount the ESC in airflow on the side of the electric motor mount, using a velco strap.
The cowl is fixed in 4 places, 2 at the top and 2 at the bottom. Place masking tape over the bottom 2 and pierce where the blind nut hole is.
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
