www.aeroplusrc.com
At the rear of the fuselage you will find a ply wood area, lay the CF gear on this and mark the 3 holes. Taking care to make sure it is straight.
Drill each hole with a fine drill and drop thin cyno into the holes to strengthen the wood.
Screw the gear on with the supplied self taping screws.
Drill a hole in the base of the rudder for the rudder steering guide.
Before gluing with cyano, place it over the thin rod.
Aileron Servos
The ailerons on the wings are pre‐glued. Check each one by gently pulling to make sure that they are secure
Remove the covering where the aileron horns are glued in place. Use either a soldering iron or a sharp knife
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com