Advertisement
www.aeroplusrc.com
Rear Stab
Remove the elevators and hinges from the rear stab and place it in the opening.
It is important that care is taken when aligning the rear stab. Measure each side to make sure that an equal amount shows on each side.
Fit the CF wing tube and looking from the front and back check that the elevator plate is in horizontal alignment to the rear stab. If it is not then trim
the opening so that it is equal.
Fit the wings and measure from the end of the wing to the elevator stab to make sure that both sides are equal
Glueing – Once you think you are ready to glue, measure again. We recommend 2 methods for gluing. Either remove the covering on the area that is
covered by the fuselage and glue with CA or epoxy, or leave the covering on and glue with thin cyno. Wicking in thin first, if a large gap is visible then
use medium or thick. Remember to wick in small amounts at a time keeping the plane level, this will ensure the glue stays where it needs to be.
Depending on if you are fitting 1 or 2 elevator servo's you may need to fit the elevator joining bar.
Glue the joiner bar into 1 of the elevator halves with epoxy.
Now we can hinge one of the elevators with the joiner bar glued in.
Use thin CA to glue the hinges in place, making sure that equal amount can go into each half. Flex the hinges once glued.
Dry fit the other elevator half with the hinges and make sure that both halves align to the stab. Trim where the joiner bar sits if required.
Glue the hinges in both stab and elevator again. While gluing use tape to keep it in alignment
Remove the covering for the elevator servo
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
