Advertisement
www.aeroplusrc.com
Remove the covering where the elevator horns fit, use either a soldering iron or a sharp knife.
The area on the horns that goes inside the elevator needs to be roughed up with sandpaper. This allows a better glue joint.
Glue the horns in place with epoxy glue or CA.
Before fitting the elevator servo fix an extension lead so that the wire can be routed through the fuselage. On the servo lead joint add a servo plug
clip.
Fit the Elevator Servo servo and using a fine drill, drill holes for the servo screws. Remove the servo and drop thin cyno into all 4 holes.
Re‐fit the elevator servo and secure it in with servo screws.
Centre the servo using your TX, and fit a servo arm. Screw ball joints onto the pushrod (use pliers to hold pushrod) and bolt in place with supplied
bolts. Centre of servo should align with elevator flat to the stab.
If you are using dual elevator servos then repeat the process on the other side.
www.modellmarkt24.ch
www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
