www.aeroplusrc.com
Refit the cowl and drill where the marked hole was.
RX
A convienient place to mount the RX is just in front of the rudder servo. Ensure that it is mounted on velco and strapped down.
Canopy
The canopy is held in place with the lock. Ensure that it is fully engaged before flying.
Set‐up
We highly recommend the use of both dual rates and exponential. This will allow the model to fly both precision and 3D at the flick of a switch.
Low Rates
Elevator 15‐20 deg
Ailerons 15‐20 deg
25‐30 deg
Rudder
For test flights always use low rates, remember that + and – exponential is different per manufacturer, check your TX manual.
Always check the range on your model before the maiden flight. Carry out a short flight then go over everything to make sure nothing has come loose.
CG Location
We suggest for initial test flights set the CG 92mm or 3 2/3 inches from the leading edge of the wing.
Adjust after first flights to personal preference.
www.modellmarkt24.ch
www.modellmarkt24.ch
High Rate
Exponential
15‐20 %
35‐45 deg
15‐20 %
35‐45 deg
15‐20 %
35‐45 deg
AeroPlus RC Copyright 2013 © All Rights Reserved
Exponential
45‐60 %
45‐60 %
45‐60 %
service@aeroplusrc.com