AeroPlus Corvus Racer 540 59 Quick Start Manual page 6

www.aeroplusrc.com
Rudder

Remove the covering where the rudder horns push through with either a knife or soldering iron.

Test fit the rudder horns

Sand the area on the horn that fits inside the rudder so the glue bonds better

Glue the rudder hinges into both the rudder using CA. While drying use tape to keep it in alignment.

Glue the rudder horns through the rudder with CA.

Assemble the rudder servo control arm as below, drill holes for screws and use cyno to stop the nuts from coming loose.
www.modellmarkt24.ch www.modellmarkt24.ch
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com