Table of Contents
Advertisement
Available languages
Available languages
2. PREPARE INSTALLATION
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Range hood
- Wood strip (attached to back of hood)
- Installation manual
- Accessories:
• 4 Baffle filters with handles
• Grease tray with handle
• Shielded halogen bulbs (120 V, 50 W max., MR16 with GU10 base) (2 for 36" and 42" width hoods, 3 for 48" and 60" width hoods)
• Bag of parts: 3 waterproof wire connectors, 2 no. 8 x 5/8" screws, 6 no. 10 x 2" hex head screws, 4 no. 10 x 2" flat head screws,
2 wall anchors, 6 washers 3/16" ID x 3/4" OD, 4 stainless steel 10-32 locknuts
Included in parts bag, but not to be used (please discard):
2 wire clamps LP16-AP, 2 no. 8 x 3/8" zinc-plated screws, 8 no. 8 x 3/8" stainless steel screws
Parts sold separately:
- Interior blower assembly model P12
- In-line blower assembly model ILB11
- Exterior blower assembly model EB12 or EB15
- ABWPD Series Backsplash, 36", 42" or 48" width (optional)
- AEWPD Series Decorative flue, to be installed over the hood (optional)
- AWWPD Series Wall extension, 36", 42", 48" or 60" width (optional)
- Transitions, duct, elbows, dampers, wall and roof caps
Refer to page 4 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
3. INSTALL BACKSPLASH (OPTIONAL)
ABWPD Series (for 36", 42" and 48" widths range hoods only)
Backsplash must be installed before the hood shell and wall extension (if needed) because the hood shell (and wall extension) covers the
backsplash top mounting screws (see instructions packed with backsplash).
4. INSTALL WOOD MOUNTING STRIP
Due to the weight of this hood, ensure that the wood strip is attached to all of the available wall studs and blocking;
not into the wall alone.
1. Proper structural support is required to accommodate the weight of the hood. Construct the wall framing using minimum 2" x 4" lumbers.
2. Mark the center location of the hood.
3. Measure and mark a level line on wall above cooktop
location for the wood mounting strip. Install 2" x 4" blockings
between wall studs where mounting strip will be installed.
Refer to illustration at right.
4. Remove wood mounting strip from back of hood.
5. Position the wood mounting strip on the wall and secure to
the wall studs and blockings using 4 no. 10 x 2" flat head
screws (included in parts bag).
WARNING
!
CAUTION
Existing
Wall Studs
HD0482A
5
Back of Hood
2" x 4"
Wood Mounting
Blocking
Strip
18"
16"
14¼" 15
1
⁄
"
8
Advertisement
Table of Contents
