Table of Contents
Advertisement
INSTALLATION PROCEDURE
FIGURE 5
FIGURE 6
MOUNTING TRIM PANELS
3.
Slide unit out of the fireplace far enough to work behind trim panel reference lines.
4.
Mount side trim panels. (See Figure 6).
a.
Position trim panel on reference line.
b.
Drill mounting holes in center of trim panels mounting brackets to allow for adjustment in and out if
necessary.
c.
Mount trim panel using self-tapping screws provided.
5.
Place top panel back on reference mark. Take top trim panel mounting bracket supplied with unit. Position
bracket so it overlaps rear lip of top trim panel. Drill mounting holes in top of stove using holes in bracket as
guide. Tighten down screws.
6.
Now, follow installation procedures in the listed direct connect or positive connect kit you are using and install
heater connect kit in the fireplace.
7.
Slide unit back into fireplace. Check to be sure that trim panels are properly positioned and lie flat against
front of fireplace. If one or more of the panels is out of position, slide unit out and reset by loosening
mounting screws and repositioning in slot.
8.
Reinstall top trim panel by sliding rear lip of top trim panel underneath front lip of mounting bracket already
secured to top of unit.
NOTE: Mount top trim panel so that it sits in front of top of side trim panels.
9.
Obtain brass trim kit provided with unit and slip over top and sides of trim panels. (Top ends of brass may
need to be trimmed to fit).
POSITIONING
Page 8
(Use a Listed Direct or Positive Connect)(See Page 6).
POSITIONING THE HEATER
NOTE: If the three suggested installations have been
chosen, certain steps must be followed when installing
heater into a masonry fireplace.
When positioning heater, the following conditions
MUST be met! (See Figure 5).
1.
The front of damper opening must be positioned
BEHIND back edge of the lintel to ensure proper
draft. (See Figure 5).
2.
Center heater in fireplace opening.
MOUNTING THE TRIM PANELS
After unit is positioned as shown in (Figure 8), mark
mounting position of trim panels as follows:
1.
Place side trim panels in place, flat against the face
of the fireplace. Mark down front edge of trim panel
with a pencil to make a vertical reference line. (See
Figure 6).
2.
Place top (long) trim panel in place on top of unit.
The panel should be flat against the outside face
of fireplace and standing vertically. Mark along
lower edge of trim panel with a pencil to make a
reference line for mounting.
Advertisement
Table of Contents
