Table of Contents
Advertisement
Figure 27. Removing the drive from the drive carrier
Next step
If applicable, install the drive into the drive carrier.
Related link
Removing the front bezel
Installing a drive into the drive carrier
Installing a drive blank
Installing a drive into the drive carrier
Installing a drive into the drive carrier
Prerequisites
Follow the safety guidelines listed in
CAUTION:
Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1
Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2
Align the screw holes on the drive with the screws holes on the drive carrier.
When aligned correctly, the back of the drive is flush with the back of the drive carrier.
3
Using the Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
Safety
instructions.
Installation and Service Manual
Installing and removing system components
75
Advertisement
Table of Contents
