Table of Contents
Advertisement
BERNINA Stitch Regulator (BSR)
> Insert the cable of the BSR Foot into the connection (1).
1
> Switch the machine on.
– The BSR display opens and the BSR1 Mode is activated.
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The standard stitch length is 2 mm. When sewing small shapes and stippling it is recommended to shorten
the stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the BSR foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the BSR foot from the machine.
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot.
11.6 Using the BSR mode
The BSR function can either be operated via the foot control or via the button «Start/Stop».
Starting via the foot control: The foot control needs to be pressed while quilting. The machine keeps running
in the BSR1 Mode until the foot control is released, even if the fabric isn't moved.
If quilting BSR2 Mode is stopped, the machine sews another stitch depending on the needle position and
stops with needle position up.
120
Advertisement
Table of Contents
