Changing The Presser Foot Sole; Using The Bsr Mode - Bernina 590 Instructions Manual

BERNINA Stitch Regulator (BSR)
> Insert the cable of the BSR foot into the connection (1). The BSR plug must be inserted vertically.
1
> Switch the machine on.
– The BSR display opens and the BSR 1 mode is activated.

Changing the presser foot sole

NOTICE
The lens of the BSR presser foot is dirty.
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
The basic stitch length is 2 mm. When sewing small shapes and stippling, it is recommended to shorten the
stitch length to 1 – 1.5 mm.
> Raise the needle.
> Raise the BSR foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the BSR foot from the machine.
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot.

11.6 Using the BSR mode

The BSR function can be controlled via the foot control or the button «Start/Stop».
Starting via the foot control: The foot control needs to be pressed while quilting. The machine keeps running
in the BSR1 mode until the foot control is released, even if the fabric isn't moved.
If quilting is stopped in the BSR2 mode, the machine sews another stitch depending on the needle position
and stops with needle position up.
135