Specifications; Attachments/Accessories; Before Operation; Before Operation Safety - Toro TimeCutter MyRIDE 75747 Operator's Manual

Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
Foot Pedal Deck-Lift System
Certain Models Only
The foot pedal deck-lift system allows you to lower and
raise the deck from the seated position. You can use
the foot pedal to lift the deck briefly to avoid obstacles
or assist in adjusting the height of cut

Specifications

Specifications and design are subject to change
without notice.
42in Mower
Deck
Cutting width 107 cm (42
inches)
Width with 135 cm (53
deflector inches)
down
Width with
123 cm (48.5
deflector inches)
raised
Length 185 cm (73
inches)
Height 112 cm (44
inches)
Weight 724 kg
(724lb)

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
(Figure 24).
(Figure
50in Mower 54in Mower
Deck Deck
127 cm (50 137 cm (54
inches) inches)
155 cm (61 165 cm (65
inches) inches)
130 cm (51 140 cm (55
inches) inches)
186 cm (73 187 cm (73
inches) inches)
113 cm (44 144 cm (45
inches) inches)
353 kg (779 379 kg (836
lb) lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

General Safety
•
Do not allow children or untrained people to
operate or service the machine. Local regulations
4).
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Inspect the area where you will use the machine,
and remove all objects that could interfere with
the operation of the machine or that the machine
could throw.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Check that operator-presence controls, safety
switches, and guards are attached and working
properly. Do not operate the machine unless they
are functioning properly.
•
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's position. Allow the machine to cool
before servicing, adjusting, fueling, cleaning, or
storing it.
•
Before mowing, inspect the machine to ensure
that the cutting assemblies are working properly.
•
Evaluate the terrain to determine the appropriate
equipment and any attachments or accessories
required to operate the machine properly and
safely.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose clothing or loose
jewelry.
•
Do not carry passengers on the machine.
•
Keep bystanders and pets away from the machine
during operation. Shut off the machine and
attachment(s) if anyone enters the area.
•
Do not operate the machine unless all guards and
safety devices, such as the deflectors and the
entire grass catcher, are in place and functioning
properly. Replace worn or deteriorated parts when
necessary.
13