Toro TimeCutter MyRIDE 75747 Operator's Manual page 47

Figure 67
Mower Decks with 3 Blades
1. Wood block—6.6 cm
(2-5/8 inches) thick
6. Remove the hairpin cotter and washer from the
lower lift-arm pin (Figure
Figure 68
1. Height-of-cut plate
2. Hairpin cotter
7. Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
g298028
2. Wood block—7.3 cm
(2-7/8 inches) thick
68).
g294197
3. Washer
(Figure 69).
8. Install the washer and hairpin cotter
9. Repeat steps
the machine.
10. Check the side-to-side level again; repeat this
procedure until the measurements are correct.
11. Continue leveling the mower deck by checking
the front-to-rear blade slope; refer to
the Front-to-Rear Blade Slope (page
Adjusting the Front-to-Rear Blade
Slope
1. Rotate the adjustment nut in the front of the
mower (Figure
1. Adjusting rod
2. Adjusting block
2. To raise the front of the mower deck, tighten the
adjustment nut.
47
Figure 69
6 through 8 for the other side of
70).
Figure 70
3. Adjustment nut
g294195
(Figure 69).
Checking
45).
g294471