Table of Contents
Advertisement
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Set the height of cut to 76 mm (3 inches).
4.
Carefully rotate the blades so they are facing
front to rear
(Figure
5.
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat
surface
(Figure 64
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade
tip, continue to the
Blade Slope (page 47)
Figure 64
Mower Decks with 2 Blades
1. Blades front to rear
2. Outside cutting edges
Figure 65
Mower Decks with 3 Blades
1. Blades front to rear
2. Outside cutting edges
64).
or
Figure
65).
Adjusting the Front-to-Rear
procedure.
3. Measure from the tip of the
blade to the flat surface
here.
3. Measure from the tip of the
blade to the flat surface
here.
Leveling from Side to Side
1.
Move to the left side of the machine.
2.
Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to
Adjusting the Anti-Scalp Rollers (page
3.
Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page
23).
4.
Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets
5.
Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck
(Figure 66
g294046
Mower Decks with 2 Blades
1. Wood block—6.6 cm
(2-5/8 inches) thick
g296914
46
Adjusting the Height of Cut
(Figure 66
or
Figure
67).
or
Figure
67).
Figure 66
2. Wood block—7.3 cm
(2-7/8 inches) thick
24).
g298027
Hide quick links:
Advertisement
Table of Contents
