Table of Contents
Advertisement
The preferred method of fixing which is suitable for almost all situations is
the cable fixing method which is described in the following section in detail.
If the 2" black spacer is used, the fire may be secured using the cable method as
described below, or alternatively, in installations where the cable method is not
suitable (eg. loose masonary in rear of fire opening) the spacer may be removed
from the fire box and secured to the fire surround using protruding screws which
engage on to the key hole slots on the rear face of the spacer. The spacer will
then need to be sealed to the fire surround. The fire box can then be refitted to
the spacer.
To fit using the preferred cable method proceed as follows-
e)
Mark out and drill 4 off No 14 (6mm) holes in the back face of the fire
opening in the positions shown below in fig. 7
Fig. 7
500mm
Fit the wallplugs provided and screw the fixing eyes securely into the rear of the
fire opening. If the clearance at the rear of the fire is at the minimum specified for
a precast flue application, it may be necessary to bend over the lower fixing eyes
after screwing them fully in to the rear of a pre-cast starter block.
f)
Uncoil the two fire fixing cables and thread one end of each of the
cables through one of the two holes on each side of the flue outlet
shroud.
g)
Position the fire carefully on the (protected) surface of the hearth and
reach into the fire opening. Thread each of the cables vertically
downwards through the pair of fixing eyes on the same side of the fire.
Thread the free end of the cables through the corresponding circular
hole on each side of the lower rear of the fire. Carefully slide the fire
box back into the fire opening and pull both cables tight.
Supplied By www.heating spares.co Tel. 0161 620 6677
250mm
Fireplace Opening
100mm
20mm
13
Advertisement
Table of Contents
