Troubleshooting - Ikelite 6973.06 Manual

8. Like regulators and other pressure-sensitive equipment, we
recommend careful care and cleaning along with annual
replacement of the factory seals.

Troubleshooting

Water enters the housing
•
Re-clean and re-install the main o-ring.
•
Take the housing underwater without a camera installed to ensure
that the leaking has been corrected.
Photos are over-exposed (too light)
•
Adjust aperture (smaller), shutter speed (faster), or ISO (lower)
setting.
•
Move lights(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Photos are under-exposed (too dark)
•
Adjust aperture (larger), shutter speed (slower), or ISO (higher)
setting.
•
Move light(s) closer to your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Strobe will not fire
•
Turn on strobe and make sure it is properly charged.
•
Remove Hotshoe from camera mount if using a fiber optic strobe.
The internal camera flash is disabled when the Hotshoe is
connected.
17