Wifi Connection - NuWave OXYPURE 47001 Owner's Manual

THE NUWAVE CONNECT APP
MONITOR AND CONTROL THE OXYPURE REMOTELY
Using the built-in QR reader in your
Camera App:
1
Scan the QR code below.
2
It will take you to the App's download
page on either the Google
the Apple AppStore, then just follow the
download and installation instructions.
If your phone does not have that
capability built-in, download a 3rd-Party
QR Scanning App or you can download
the App from the Google™ Play Store or
the Apple AppStore.
Wi-Fi
1. Download the NuWave® Connect app via
the Apple Store or Google™ Play Store
on your smartphone or device and open
the app.
2. Plug in the unit and be sure your phone
is connected to your network. will only
connect to a 2.4GHz* network.
3. Open the app and follow the instructions
for the verification process.
4. Activate the Wi-Fi Pairing Mode by
pressing and hold POWER until the light
next to the Wi-Fi symbol begins to blink
rapidly.
For Android Users:
1. Begin adding the device, tap "+" then
select the "OxyPure" to be added. You
can look at the label at the back of the unit
for the correct name.
2. If the device appeared, press "Go to add".
3. If selected by the device name, confirm
"the Wi-Fi indicator is blinking rapidly".
8 | OxyPure Smart
4.
5.
For iPhone users:
1.
2.
Play Store or
™
3.
4.
5.
6.
Pairing with AP Mode:
If your device cannot connect to your Wi-Fi
network, you can pair your OxyPure with your
phone using AP Mode.
•
Note:
To either connect to or change networks,
depending on your cellular service, you
may need to remove the app and reinstall
it to complete the connection before
continuing with the setup process.
When the OxyPure is connected to the Wi-
Fi, the light next to "Wi-Fi" will stop flashing
and stay continuously lit.
If the OxyPure did not connect to your
network, the Wi-Fi light will turn off. Repeat
the steps for pairing. Make sure to select
the proper Wi-Fi network and type the
correct password.
The OxyPure, as with most IoT devices
(computing devices), will only connect to a
2.4GHz* network.
Then press "Next" to confirm the Wi-Fi
password.
Once added successfully, press "Next" if
appears, then tap "Done".
Once the NuWave Connect App and tap
the"+" sign in the top right corner.
Tap on Auto Scan and wait a few seconds
for your OxyPure to appear on the screen.
Then verify the Wi-Fi network and
password.
Tap "Next" to begin pairing!
Once added successfully, a green √ will
appear, then press "Next".
Will show the unit "Added", press "Done"
in the upper right corner.
When selecting your device to pair with,
tap EZ Mode in the top right and switch
to AP Mode. Then you simply follow the
instructions on the screen.