Wifi Connectivity - NuWave OXYPURE ZERO E1000 Owner's Manual

The OxyPure is equipped with Wi-Fi allowing you to operate the OxyPure from any location. To set
®
up and activate the Wi-Fi:
1. Download the NuWave
your smartphone or device and open the app.
2. Make sure your phone is connected to your network. Open the app and follow the
instructions for the verification process. Once verification is complete, begin adding
devices. To add a device, tap "+" then select "OxyPure."
3. Next, plug the OxyPure into a compatible power outlet. To activate Wi-Fi Pairing
Mode, press and hold ULTIMATE CLEAN until the light next WIFI begins to blink at
a rate of about 2 blinks per second. Once the Wi-Fi light is rapidly blinking, in the
app, tap Next on the bottom of the Add Device page.
4. Next, you will be prompted to either connect to your network or confirm your existing
network password. Then tap Next to begin the scanning process.
Note: To either connect to or change networks, depending on your cellular service, you
may need to remove the app and reinstall it to complete the connection before continuing
with the setup process.
5. When the OxyPure is connected to the Wi-Fi, the light next to "WIFI" will stop flashing
and stay continuously lit.
6. If the OxyPure did not connect to your network, the WIFI light will turn off. Repeat
steps 3-4. Make sure to select the proper Wi-Fi network and type the correct
password.
Note: The OxyPure, as with most IoT devices (computing devices), will only connect to a
2.4GHz* network.
7. To reset the OxyPure WIFI, press and hold down ULTIMATE CLEAN for until the light
blinks rapidly. Follow Step 4 (see above). The OxyPure can now be operated from any
location.
*Most routers will broadcast in 2.4GHz. If you need help activating 2.4GHz, contact your
ISP (Internet Service Provider).
Solid Light
The OxyPure is paired with the Wi-Fi and ready to be used.
®
Rapid Blinking Light
The OxyPure is in Pairing Mode. The OxyPure will remain in Pairing Mode for up to 3
minutes, or until your device is paired.
Slow Blinking Light
The OxyPure is in Standby Mode.
No Light
The OxyPure's Wi-Fi is off.
Note: If the light on your OxyPure is blinking slower, the OxyPure is in Wi-Fi Standby
Mode. To exit Standby Mode and initiate the Pairing Mode, press and hold ULTIMATE
CLEAN or until the Wi-Fi light begins blinking rapidly.

WIFI CONNECTIVITY

CONNECTING TO THE NUWAVE CONNECT APP
Connect app via the Apple Store or Google
®
Wi-Fi LED Status
Pairing Mode & Standby Mode
Play Store on
™
nuwavenow.com | 9