Advertisement
3. Put the guide bar above the bar bolts.
Steer the guide bar to its most rear
position.
4. Put on protective chainsaw gloves.
5. Lift the saw chain above the drive sprocket
and engage it in the groove on the guide
bar. Start on the top edge of the guide bar.
6. Make sure that the edges of the cutting
links are turned forward on the top edge of
the guide bar.
7. Assemble the sprocket cover and steer the
chain adjuster pin to the hole in the guide
bar.
12
8. Make sure that the drive links of the saw
chain fit correctly on the drive sprocket.
Also make sure that the saw chain is
correctly engaged in the groove in the
guide bar.
9. Tighten the guide bar nuts with your
fingers.
10.Tighten the saw chain by turning the chain
tensioning screw clockwise with the
combination wrench
. Tighten the saw chain until it does not sag
from below the guide bar, but you can turn
it easily by hand.
653 - 006 - 10.02.2020
Advertisement
