Advertisement
8. Continue to pull the starter rope handle
until the engine starts or tries to start (pull
max 5 times).
9. If the engine starts or tries to start, push the
choke control in to the half choke position.
10.Continue to pull until the engine starts.
11.Hold the rear handle with your right hand
and the front handle with your left hand.
12.Immediately pull the front hand guard
rearward in the direction of the front handle
to disengage the chain brake.
Note:
The chain will move.
13.Run 20-30 seconds at elevated idle speed.
18
14.Pull the throttle trigger slowly but fully for
8-10 seconds, then release.
15.Run 10 seconds at normal idle speed.
16.Pull the throttle trigger slowly but fully for 5
seconds to check acceleration, then
release.
17.Use the product.
To start a warm engine
1. Move the front hand guard forward to
engage the chain brake.
2. Pull the choke control out fully.
3. Push the air purge bulb 6 times.
4. Push the choke control in fully.
5. Hold the body of the product on the ground
with your left hand.
6. Put your right foot through the rear handle.
7. Pull the starter rope handle slowly with your
right hand until you feel some resistance.
8. Pull the starter rope handle with force.
CAUTION:
starter rope until it stops. Do not
let go of the starter rope when it
is fully extended. Release the
starter rope slowly. If you do not
obey these instructions, it can
cause damage to the engine.
Note:
Do not pull the throttle trigger when
you start the engine.
9. Pull the starter rope handle until the engine
starts.
10.Hold the rear handle with your right hand
and the front handle with your left hand.
Do not pull the
653 - 006 - 10.02.2020
Advertisement
