Advertisement
4. Remove the knob (A) and the sprocket
cover. Remove the transportation guard, if
installed.
A
5. Put the guide bar over the bar bolts. Steer
the guide bar to its most rear position. Put
the chain over the drive sprocket and
engage it in the groove on the guide bar.
Start on the top edge of the guide bar.
6. Make sure that the edges of the cutting
links are turned forward on the top edge of
the guide bar.
14
7. Assemble the sprocket cover and steer the
chain adjuster pin to the hole in the guide
bar. Make sure that the drive links of the
chain fit correctly on the drive sprocket.
Also make sure that the saw chain is
correctly engaged in the groove in the
guide bar.
8. Tighten the saw chain by turning the wheel
down (+). Tighten the chain until it does not
sag from below of the guide bar.
9. The saw chain is correctly tightened as it
does not sag from below the guide bar, but
you can turn it easily by hand.
653 - 006 - 10.02.2020
Advertisement
