Advertisement
11.Immediately pull the front hand guard
rearward in the direction of the front handle
to disengage the chain brake.
Note:
12.Wait 10-15 seconds.
13.Pull the throttle trigger lightly to set normal
idle.
14.Use the product.
To start the engine when the fuel is too hot
If the product does not start, the fuel can be
too hot.
Note:
Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from
open sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again
for 10-15 seconds.
4. Obey the procedure to start a cold engine.
To start a cold engine on page 17 .
Refer to
To stop the engine
• Push the stop switch to stop the engine.
Note:
The stop switch automatically goes
back to its initial position.
To fell a tree
1. Remove dirt, stones, loose bark, nails,
staples and wire from the tree.
653 - 006 - 10.02.2020
The chain will move.
2. Make a notch 1/3 the diameter of the tree,
perpendicular to the direction of the fall.
3. Make the lower horizontal notch cut. This
will prevent either the saw chain or the
guide bar from being pinched when the
second notch is made.
19
Advertisement
