Advertisement
• Remove the spark plug cable before you
put the product into storage to make sure
that the engine does not start accidentally.
Safety instructions for maintenance
• Disconnect the spark plug before doing
maintenance on the product, not including
carburetor adjustments.
• Have all product servicing done by an
approved dealer, not including the tasks in
Maintenance on page 22 .
• Make sure the saw chain stops moving
when the throttle trigger is released.
• Keep the handles dry, clean, and free from
oil or fuel mixture.
• Keep caps and fasteners correctly
tightened.
• Replacement components that are not
approved or the removal of safety devices
can cause damage to the product. This can
also cause possible injury to the operator
or bystanders. Only use accessories and
replacement parts as recommended. Do
not change your product.
• Keep the saw chain sharp and clean for
safe and high performance.
WARNING:
the safety chapter before you
assemble the product.
To assemble the guide bar and saw
chain (standard chain adjustment)
1. Remove the spark plug cap from the spark
plug during assembly to prevent an
accidental start.
653 - 006 - 10.02.2020
Assembly
Read and understand
• Obey the instructions for lubricating and
changing accessories.
• Examine the product for damaged parts.
Before more use of the product, make sure
the damaged guard or part operates
correctly. Examine for broken or incorrectly
aligned parts, and parts that do not move
freely. Examine for other conditions that
can have an effect on the operation of the
product. Make sure the product is correctly
installed. A guard or other damaged part
must be repaired or replaced by an
approved dealer unless written in the
operator's manual.
• When not in operation, keep the product in
a dry, high or locked area away from
children.
• During transportation or storage of the
product, use a transportation guard or case
to move the product.
• Do not use waste oil. Waste oil can be
dangerous to you and can cause damage
to the product and environment.
2. Remove the bar nuts and the sprocket
cover. Remove the transportation guard
(A).
A
11
Advertisement
