Related Manuals for K&S BASIC KSB 21i S
Summary of Contents for K&S BASIC KSB 21i S
- Page 1 OWNER’S MANUAL Please, read this manual carefully before use! Inverter Generator KSB 21i S KSB 21i KSB 35i KSB 31iE S...
-
Page 2: Safety Information
INTRODUCTION Thank you for your purchase of K&S Basic products. This manual contains a brief description of safety, use and debugging. More information can be found on the official manufacturer’s website in the support section: ks-power.de/betriebsantleitungen. You can also go to the support section and download the full version of the manual by scanning the QR code, or on the website of the official importer of K&S Basic products: www.ks-power.de/en. -
Page 3: Specifications
Fuel contaminates the land and groundwater. Do not ATTENTION – DANGER! allow the leaking gasoline from the tank! SPECIFICATIONS Model KSB 21i S KSB 21i KSB 35i KSB 31iE S Max Power, kW Nominal Power, kW Engine power, hp... -
Page 4: Main Overview
MAIN OVERVIEW MODELS KSB 21i S, KSB 31iE S 1.Transport handles 2. Fuel tank cap 3. Control panel 4. Starter 5. Maintenance panel 6. Ventilation grille 7. Silencer 1. 12V outlet’s overload protector 2. 12V outlet 3. Oil level indicator 4. -
Page 5: Terms Of Use
To enable engine turn the start switch to ON position. To eliminate the engine, turn the switch to STOP position. For model KSB 21i S, the engine switch is combined with the fuel valve handle. To turn on the engine, turn the fuel valve to the “ON”... -
Page 6: Ac Pilot Light (Green)
FUEL TANK CAP AIR VENT KNOB The fuel tank cap is provided with an air vent knob to stop fuel flow (for models KSB 21i S, KSB 31iE S). The air vent knob must be turned to “ON”. This will allow fuel to flow to the carburetor and the engine to run. When the engine is not in use, turn the air vent knob to “OFF”... -
Page 7: Before Starting
BEFORE STARTING CHECK THE FUEL LEVEL 1. Remove the fuel tank cap and check the fuel level. 2. Add fuel to the filter level if necessary. 3. Screw the fuel tank cap back tightly. Immediately wipe off spilled fuel with a clean, dry, soft cloth, since fuel may deteriorate painted surfaces or plastic parts. -
Page 8: Engine Start
2. Allow the generator to operate at idle for 1-2 minutes for the alternator to cool down. 3. Set the engine switch to OFF (for model KSB 21i S, the engine switch is combined with the fuel valve handle). | 23... -
Page 9: Alternating Current (Ac)
4. Turn the fuel valve to the “OFF” position. 5. After the generator stops, allow it to cool down and close the vent (for model KSB 21iS, KSB 31iE S). COMMISSIONING The first 20 hours of generator work please comply the following requirements: 1. -
Page 10: Technical Maintenance Works
IMPORTANT! - Be sure the ECON is turned off while charging the battery. - Be sure to connect the red battery charger lead to the positive (+) batteryterminal, and connect the black lead to the negative (-) battery terminal. Do not reverse these positions. - Connect the battery charger leads to the battery terminals securely so that they are not disconnected due to engine vibration or other disturbances. -
Page 11: Recommended Oils
TECHNICAL MAINTENANCE WORKS Node Service type Checking level Motor oil Changing Checking Air filter Cleaning Cleaning Sparking plug Changing Checking level Fuel tank Cleaning Fuel filter Changing - If the generator is often working at high temperature or at high load, the oil should be replaced every 25 operating hours. -
Page 12: Cleaning The Filter
1. Open the air filter cover (Fig. 1 for models KSB 21i, KSB 35i; Fig. 1, 2 for models KSB 21i S, KSB 31iE S). 2. Remove the sponge filtering element. 3. Remove all dirt deposits inside the hollow case of the air filter. -
Page 13: Spark Plug Inspection
Spark plug SPARK PLUG INSPECTION: 1. Remove the cap from the spark plug. 2. Remove the spark plug by means of a corresponding spanner. 3. Examine the spark plug. If it is shattered – it is necessary to replace it. Recommended replacement spark plugs –... -
Page 14: Generator Storage
GENERATOR STORAGE The generator must be stored in a dry, well-ventilated area that is free from dust. Keep away from children and animals. Generator should always remain ready for operation. Therefore in case of device malfunctions, they are to be repaired before IMPORTANT! dismounting the generator for storage. - Page 17 KONTAKTDATEN Deutschland: DIMAX International GmbH Deutschland, Hauptstr. 134, 51143 Köln, www.ks-power.de info@dimaxgroup.de Polska: DIMAX International Poland Sp.z o.o. Polen, Warczawska, 306B 05-082 Stare Babice, www.ks-power.pl info.pl@dimaxgroup.de Україна: ТОВ «Техно Трейд КС», вул. Електротехнічна 47, 02222, м. Київ, Україна www.ks-power.com.ua sales@ks-power.com.ua Россия: ТД...