Brother BAS-342G Basic Operation Manual page 42

7. SEWING
7-2. Using the STOP switch
If you press the STOP switch (1) while sewing or test feeding is in progress, the CAUTION indicator (2) will illuminate and
the sewing machine will stop immediately.
4982Q
<Continuing sewing from a stopping point>
If you have pressed the STOP switch (1) at times such as if the thread breaks while sewing or the lower thread runs out, you
can resume sewing from the point where the thread ran out.
1
2
3
7-3. Using the thread wiper switch
34
<Clearing>
2264B
1. Press the RESET key (3).
• The thread will be trimmed, and then the CAUTION
indicator (2) will switch off and the buzzer will stop
sounding.
2. If you do not wish to continue sewing, press the RESET
key (3) once more.
• The program number will flash. Carry out preparation
for the next sewing.
Press the RESET key.
• The thread will be trimmed, and then the CAUTION indicator will switch
off and the buzzer will stop sounding.
Press the key to return the work clamp to the position where sewing is
to be continued.
• When the
key is pressed, the work clamp will move backward by one
stitch, and when the
forward by one stitch. (It will move quicker if you keep the key pressed
down.)
Depress the start switch (4).
•
The sewing machine will start operating and sewing will start.
The thread wiper switch (1) can be used to turn the thread
wiper (2) on and off.
4023M
BAS-342G
key is pressed, the work clamp will move
4443Q
4022M