Brother BAS-342G Basic Operation Manual page 41

7. SEWING
Turn off the power switch at the following times.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
• When threading the needle
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
7-1. Sewing
Use a work clamp and a feed plate which will hold the article securely so that it does not slip.
If using the standard work clamp and feed plate and the article being sewn is slipping, take measures to stop the work
clamp and feed plate from being slippery.
CAUTION
1. Turn on the power switch.
4978Q
2. Press the
number that you would like to use.
* Refer to "6-2. Loading sewing data" for details on
reading sewing data from a CF card.
3. Depress the work clamp switch (2) to lower the work
clamp (3), and then depress the start switch (4).
• The work clamp will move to the sewing start
position.
• Home
immediately after the power switch is turned on.
4020M
4. Place the article to be sewn underneath the work clamp
(3).
5. Depress the work clamp switch (2).
• The work clamp (3) will drop.
6. Depress the start switch (4).
• The sewing machine will start sewing.
7. When sewing is complete, the thread will be trimmed
and the work clamp (3) will rise.
2577B
BAS-342G
or key (1) to select the sewing program
position detection will
7. SEWING
be carried out
33