Advertisement
3.19 Load Control Menus
The Load Control menu displays the status of the load
management inputs and outputs, and allows a test of the
load management output relays. This menu appears
only if a load management device is connected.
Generator current is displayed as a percent of the
maximum generator capacity. The load management
Load - - >
Control
Figure 3-23 Load Control Status Menu
48
Section 3 RDC2 Controller Operation
Generator
Current:
123 %
Load - - >
Control 1
<- - Return
device adds and sheds loads based on the generator
current.
The test function cycles the relays in the order of their
priority.
For
detailed
management operation, refer to the instructions
provided with the load shed kit or the RXT Transfer
Switch Operation and Installation Manual.
Test Outputs
Push Select (blinking)
Input 1:
In/Active
Input 2:
In/Active
Output 1:
Add/Shed
Output 2:
Add/Shed
Output 3:
Add/Shed
Output 4:
Add/Shed
Output 5:
Add/Shed
Output 6:
Add/Shed
<- - Return
information
about
load
tp6810
TP-7102 9/21
Advertisement
