Advertisement
This manual provides operation instructions for Model
48RCLB, 48RCLC, 60RCLA, and 60RCLB residential/
light commercial generator sets equipped with the
RDC2 generator set/transfer switch controller. See
Figure 1 for a typical 48 kW liquid-cooled residential
generator set.
Kohler strongly recommends that only factory-
authorized dealers or technicians install and
service the generator.
This generator set is approved for use in stationary
applications in locations served by a reliable utility
power source. Have the generator set installed by an
authorized Kohler dealer or service technician. Refer to
the Installation Manual for installation instructions.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual. Keep this manual with the
equipment for future reference.
The equipment maintenance requirements are very
important for safe and efficient operation. Inspect the
parts often and perform required maintenance at the
prescribed intervals. Obtain service from an authorized
Kohler dealer or service technician to keep equipment in
top condition.
Figure 1 Model 48RCLB Generator Set
TP-7102 9/21
Nameplate
Figure 2 shows a typical generator set nameplate.
Copy the model, serial, and specification numbers from
the nameplate into the spaces provided in the product
information section on the inside front cover of this
manual. See the service view in Section 1 for the
nameplate location.
Genset Model
Spec Number
Serial Number
Material Number
Service Duty
Voltage
Alt Model
Insulation
MFG Date
Figure 2 Nameplate, Typical
Introduction
Amps
kW
Phase
kVA
RPM
PF
Battery
Hz
Fuel
Introduction
9
Advertisement
