Advertisement
3.11 Generator Set Information
Menu
The generator set model number and serial numbers
are displayed. No changes are allowed from this menu.
Model and serial numbers are factory set and should not
require changes in the field, except in the event that the
controller is being replaced. A personal computer
running Kohlerr SiteTecht software is required to enter
the generator set model number and serial numbers on
a replacement controller. Contact an authorized Kohler
dealer for service.
Genset - - >
Information
Figure 3-11 Generator Set Information Menu
TP-7102 9/21
Genset M/N:
48RCL
Genset S/N:
########
or
Controller S/N:
########
<- - Return
tp6810
3.12 Genset Run Time Menu
The data shown in Figure 3-12 are displayed. No
changes are allowed from this menu.
The Next Maintenance menu shows the number of
hours of generator set operation until maintenance is
required. The estimated date for the next scheduled
maintenance is also displayed. The maintenance
reminder
intervals
are
manufacturer's recommendation for changing the oil.
Refer to Section 5, Scheduled Maintenance, for
maintenance instructions.
After
changing
the
recommended maintenance, go to the Overview menu
to reset the maintenance timer. See Section 5.3.4 for
instructions to reset the maintenance timer.
Genset - - >
Run Time
Figure 3-12 Generator Set Run Time Menu
Section 3 RDC2 Controller Operation
based
on
the
engine
oil
and
performing
Eng Runtime:
27.4 h
Eng Starts:
40
Next Maintenance:
150 h or Jan2019
<- - Return
other
tp6810
37
Advertisement
