Panel Replacement - REVELL Ultima Studio User Manual

Figure 14. Installing a new
REVEL ULTIMA STUDIO
side panel.

PANEL REPLACEMENT

Although your new REVEL ULTIMA STUDIO loudspeakers are
preassembled at the factory, you can replace existing side panels
with new ones as follows:
1. Lay a REVEL ULTIMA STUDIO on one side, on a soft sur-
face such as carpeting, or a thick rug.
2. Use the enclosed hex wrench to untighten the exposed side
panel bolts and remove. Remove the panel and grille.
3. Install a new side panel, as shown in Figure 14. Start all six bolts
(with trim rings) by hand and tighten them with the hex
wrench. Be careful not to overtighten.
Bolt
Trim
Ring
4. Lay the REVEL ULTIMA STUDIO on its other side, onto a
soft surface. Use the enclosed hex wrench to untighten the side
panel bolts and remove. Remove the panel.
5. Install the loudspeaker grille, as shown in Figure 15 (on the
next page). Insert the grille tips into panel cups.
Continued on the next page...
REVEL ULTIMA STUDIO
Owner's Manual
19