Safety And Information - Keysight Technologies N9029BV Product Notes

Safety and Information

8
Use the Keysight supplied power cord or one with the same or better
electrical rating.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock do not remove covers.
The Mains wiring and connectors shall be compatible with the
connector used in the premise electrical system. Failure to ensure
adequate earth grounding by not using the correct components may
cause product damage and serious injury.
If this product is not used as specified, the protection provided by the
equipment could be impaired. This product must be used in a normal
condition (in which all means for protection are intact) only.
This instrument has auto-ranging line voltage input. Be sure the
supply voltage is within the specified range and voltage fluctuations
do not to exceed 10 percent of the nominal supply voltage.
Use ESD precautions when using these devices. The IF port for CCDs has
ESD protection, but the IF port for CCUs is extremely ESD sensitive. Do not
apply any DC biases or surges when connecting or disconnecting from the
IF port. Discharge static from cables befor connecting to the device.
Replace the IF with provided 50 Ω termination when IF port is not in use.
Observe the power level you are applying to the LO, IF, and RF
waveguide input ports. Damage will occur if it is not observed.
Before using your converter module, please read all documentation from
VDI (included on the USB drive). It is important to follow the General
Operating Procedures and Guidelines section.
This product has been designed and tested in accordance with accepted
industry standards and has been supplied in a safe condition. The
documentation contains information and warnings that must be followed
by the user to ensure safe operation and to maintain the product in a safe
condition.
Only Keysight approved accessories shall be used.
The main power cord can be used as the system disconnecting device. It
disconnects the mains circuits from the mains supply.
Keysight N9029-90038