Wire The Pipe Interface Board - Bosch VG4-161-CC0 Installation Manual

VG4 Modular Camera Series
6.
7.
WARNING!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
damage or serious injury or death.
3.7

Wire the Pipe Interface Board

This section provides instructions for connecting wires and cables to the Pipe Interface
Board, as illustrated below. See Section 5 Cable and Wire Standards, page 88 for cable and
wiring recommendations and specifications.
Bosch Security Systems, Inc.
Apply the supplied thread sealant to the threads on the Pipe.
– Make sure all surfaces are clean and dry.
– Apply a bead of sealant completely around the leading threads of the male fitting.
– Force the adhesive into the threads to thoroughly fill all voids.
Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks. See
Figure 3.9, Page 58.
BNC
AGND
OUT 3
OUT 2
OUT 1
J101
P106
Figure 3.10 Pipe Interface Board Connections
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
6
5
4
3
2
1
7
6
5
4
3
2
1
3
2
1
2
1
59
F.01U.216.010 | 8.0 | 2011.02