Setting Up A Differential Beacon - Raymarine RayChart 630 Owner's Handbook Manual

Chapter 6: Customizing the Chartplotter

Setting Up a Differential Beacon

Normally, your differential beacon receiver (if fitted) automatically picks up the
transmitted differential signal. If there are two differential beacons competing
in a region, you may wish to set up the beacon manually. The Beacon Set Up
menu also indicates Beacon status and can be used to return to auto mode after
having set up the beacon manually.
To set up a differential beacon manually:
1. Press the BEACON soft key. The current settings, read from the beacon
receiver (if connected) are displayed as shown below:
2. Press ENTER, then select AUTO or MANUAL mode. When manual mode is
selected, you are prompted for frequency and bit rate.
Use the trackpad to select the required bit rate, and to edit the beacon
frequency to the required value.
3. Press ENTER to accept the changes, or CLEAR to cancel.
4. Press CLEAR or ENTER to return to the Fix Status screen, and CHART to
return to the chart.
75
D4202_1