Chapter 7: Installation; Introduction - Raymarine RayChart 630 Owner's Handbook Manual

Chapter 7: Installation

Chapter 7: Installation

7.1 Introduction

This chapter explains how to install the chartplotter. Installation should only be
undertaken by a competent installer.
The chartplotter can be trunnion (yoke) or panel mounted. It must be connected
to a power supply and to a source of position data (for example, a GPS), and can
also be connected to other units via the SeaTalk, Navaid or NMEA connections.
You can install more than one chartplotter as part of a larger system. Details of
the current route or GO TO are sent to the second unit.
An example of an integrated system is shown in the following diagram.
Extended Chartplotter System, using SeaTalk Connection Mode
GPS Antenna
GPS
Raypilot 650
Raydata
Speed
transducer
Distribution
panel
Chartplotter
Power
Raydata
Second Chartplotter
Depth
transducer
85
D3354-2