Setting Up The Data; Changing The Parameters - Raymarine RayChart 630 Owner's Handbook Manual

62

6.2 Setting Up the Data

The chartplotter allows you to set up a number of parameters that control the
way it operates. These are accessed from the SET UP menu.
The SET UP menu options control the following:
• System set up
• Navigation set up
• Chartplotter set up
• Alarms and timers set up
• Position fixer initial settings and reset
• Memory C-Card transfers
Before you make any changes:
1. Check the lists of parameters and options provided in the tables in this
section.
2. Decide what changes, if any, you wish to make.
3. Fill in the required settings in the spaces provided in the tables.
Once you have done this, follow the instructions given below to make the
changes.

Changing the Parameters

To change the set up parameters:
1. Press the MENU key to display the SET UP menu above the right hand soft
key. The option you used last is currently highlighted.
2. Use the trackpad or SET UP soft key to highlight the required menu option,
and press ENTER.
The requested set up menu is displayed, listing the parameters and their
current settings and, for some items, menus of further parameters. For
example, the SYSTEM set up menu is shown on the following page.
3. Use the up and down trackpad controls to move the highlight through the
list.
4. When the required parameter or sub-menu is highlighted, press ENTER.
For sub-menus, a further menu of parameters is displayed. Repeat steps 3
and 4 to select a parameter.
A window is displayed, listing the settings available, with the current
setting highlighted. Alternatively, for numerical parameters, a single value
(or OFF) is displayed, that can be adjusted.
RayChart 620 and 630