Table of Contents
Advertisement
6.1 Connecting the Blade
1. Shorten or remove the tractor drawbar to avoid
interference when raising and lowering the
blade.
2. Board the tractor and start the engine. Position
the tractor to the blade with the 3-point lift arms
positioned between the respective set of blade
A-frame lift lugs. Note: Set the 3-point lift
control to "Position Control" so that the lift arms
maintain a constant height when attaching the
blade. See the tractor Operator's Manual for
correct
settings
when
equipment.
3. Turn off the tractor engine, set the parking
brake, place the tractor in park, and dismount.
4. One lift arm at a time, align arm end hole
between the set of holes of A-frame lift lugs.
Insert hitch pin through the lug and arm holes
and insert retaining pin into hitch pin. Walk
around to opposite side and repeat procedure
for remaining lift arm and hitch pin.
5. Extend or retract the 3-point top link to align its
end hole with the holes of the blade top link.
Insert the top link pin and retain with cotter pin.
6. Adjust any lower link check chains, guide
blocks, or sway blocks to prevent the blade or
rake from swaying side to side and possible
contact with tractor rear tires.
IMPORTANT: Scan this QR Code with your smart phone to link to the PAMI Safe
Implement Hitching Manual for more information on correctly connecting
agricultural tractors to implements. Or type in your internet browser the following
web address: www.algqr.com/hme
SBX 48/60/65/72/78/84 09/20
© 2020 Alamo Group Inc.
OPERATION
attaching
3-point
Ops-0008-MISC
Operation Section 3-9
Advertisement
Table of Contents
