Connecting The Implement To The Tractor - Bush Hog RR1114H Operator's Manual

6. CONNECTING THE IMPLEMENT TO THE TRACTOR

Use extreme caution when connecting the implements to the tractor. The implement should be securely
resting at ground level or setting on blocks. Keep hands and feet from under the units and clear of pinch
points between the tractor hitch arms and implement pins.
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
Connect the machine to the tractor, hitching it to the drawbar at point (1).
NOTE: Do Not use screws (8) when the machine is hitched to the drawbar.
After the machine is hitched, loosen the parking stand (2) and remove pin (3), then rotate the stand upward
towards the back of the machine and insert pin (3) to hold it in the resting position. Once this procedure is
completed, insert the quick-release coupling (4) into the tractor socket and open the tap (the lever must be
parallel with the line as shown in he illustration). At this point work carefully with the hydraulic distributor to
make sure that the frame is completely lowered, then adjust the height of the tines above the ground. The
adjustment of tooth distance from the ground on the rake is controlled hydraulically by cylinder (6). By rotating
the crank (7), the tilt of the machine relative to the ground is adjusted.
Do Not Lock Hitch Swivel when connected to tractor drawbar. Bolt (8) should be removed
allowing the hitch to pivot. Ops-2611
RR1114H 04/19
© 2019 Alamo Group Inc.
OPERATION
OPS-0011_B
(S3PT-15)
Operation Section 4-8