Connecting Or Disconnecting Implement Safety Instructions And Practices; Maintenance And Service Safety Instructions And Practices - Bush Hog 1D Series Operator's Manual

Disc harrow
Table of Contents

Advertisement

Do not use harrow to lift or carry objects; to pull fence posts, stumps or other objects; or to
tow other equipment. Doing so can damage the harrow, cause serious bodily injury or
death.
Do Not operate this equipment in areas where insects such as bees, may attack you and/or
cause you to lose control of the equipment. If you must enter in such areas, use a tractor
with an enclosed Cab and close the windows to prevent insects from entering. If a tractor
cab is not available, wear suitable clothing including head, face, and hand protection to
shield you from the insects. Attacking insects can cause you to lose control of the tractor,
which can result in serious injury or death to you or bystanders. Never dismount a moving
tractor.
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the
rotating parts of the Implement. These objects could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could
result in serious injury or even death. Inspect the area for such objects before working in
the area. Remove any such objects from the site. Never allow the implement to contact
such objects.
Connecting or Disconnecting Implement Safety Instructions and Prac-
tices
Never unhitch without using the Tongue Jack. The Tongue is very heavy. Attempting to lift
the Tongue without using the Tongue Jack could cause strains or other injury. Allowing the
tongue to fall suddenly and unexpectedly could result in crushing injury. Use the Tongue
Jack for lifting the Implement only. Overloading the Tongue Jack can cause failure with
possible serious bodily injury or even death.

Maintenance and Service Safety Instructions and Practices

Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
1D/2D/3D
07/19
© 2019 Alamo Group Inc.
SAFETY
(SG-46)
(SG-40)
(STL-6)
(SG-14)
Safety Section 1-7
(STI-04)
Do not permit anyone to modify or alter this
(SG-8)
(SG-5)

Advertisement

Table of Contents
loading

This manual is also suitable for:

3d series2d series

Table of Contents