Going To An Individual Target - Raymarine Raychart 425 Owner's Handbook Manual

3-20
➤
To restart XTE:
1. Press the GOTO key.
If a GOTO is in progress, the following functions are displayed
(Figure 3-33):
2. Select RESTART XTE . The dotted line between the original origin and

Going to an Individual Target

Rather than following a route, you can go directly to a selected target.
This can be an existing waypoint, a port or nearest facility or the current
cursor position.
Go to a Waypoint
➤
To navigate directly to an existing waypoint:
1. From the normal chart display either:
...then press ENTER to display the waypoint functions (Figure 3-35):
If following a route, the following functions are displayed
(Figure 3-32):
Figure 3-32: GOTO Options (1)
Figure 3-33: GOTO Options (2)
the target waypoint is redrawn from the vessel's current position to
the target waypoint and the XTE is reset to zero
i. Use the trackpad to position the cursor over the required waypoint
until the waypoint options function is displayed (Figure 3-34):
Figure 3-34: Waypoint Options
Figure 3-35: Waypoint Functions
Raychart 425 Chartplotter
D4688_1
D4689_1