Following Routes And Going To Target Points - Raymarine Raychart 425 Owner's Handbook Manual

3-16
➤
To remove a waypoint from the route using the cursor:
1. Place the cursor over the waypoint; see Selecting a Waypoint on
2. Select WAYPOINT OPTIONS ; the Waypoint functions are displayed.
3. Select REMOVE WAYPOINT ; the waypoint is removed from the route

3.4 Following Routes and Going to Target Points

The GOTO key accesses the functions to follow a route or go to a
waypoint, port, nearest facility or current cursor position. When the target
destination is selected, the chartplotter calculates bearing, distance and
cross track error; this information can be repeated on other
instrumentation and passed to an autopilot via NMEA. Cross Track Error
(XTE) can be reset to zero from the actual vessel position.
When the chartplotter is following a route, the target destination is
indicated by a square around the waypoint (or cursor marker) and a dotted
line shows the intended track, from the start point or previous waypoint,
to the target waypoint.
This section explains how to perform the following tasks:
•
•
•
•
•
•
•
An alarm is triggered when approaching a waypoint. Chapter 4 describes
how to set the alarm.
➤
To access the follow and goto functions:
1. Press GOTO to display the first level GOTO functions (Figure 3-27):
2. Select MORE to display the second level GOTO functions
page 3-4.
and the remaining waypoints in the current route are renumbered
accordingly.
Follow a route.
Reverse a route.
Target Point Arrival.
Altering the route, including joining at a selected waypoint, advanc-
ing waypoints and restarting XTE.
Go to an individual point, either an existing waypoint or the cursor.
Go to the nearest facility or a selected port.
Stop and Restart Follow/Goto.
Figure 3-27: First Level GOTO Functions
(Figure 3-28):
Raychart 425 Chartplotter