Table of Contents
Advertisement
Chapter 2: Getting Started
2.5 Using Navionics Nav-Chart Cards
The chartplotter has a built-in world map that can be used for route
planning. Most areas (these are shown with chart box boundaries) are
covered at a range of approximately 512nm as shown on the Status Bar at
the top of the screen.
To use the chartplotter as a navigation aid, charts with detailed
information for the area you wish to navigate are required. The charts are
available on Navionics Nav-Chart cards, each of which can store up to 20
charts in an electronic format, depending upon its memory storage
capacity.
A Nav-Chart card provides an appropriate level of detail for a given
geographic area and scale; this data can be displayed down to a range of
/
nm on the screen (height) if the data is available.
1
8
To obtain Navionics Nav-Chart cards, contact your local dealer or visit
www.navionics.com
Call Navionics toll-free from anywhere in North America on:
1-800-848-5896.
Outside of North America, contact your local dealer or:
Navionics S.p.A.
Tel: (+39) 0584 961696
Fax: (+39) 0584 961309
Inserting a Nav-Chart Card
CAUTION:
To prevent the ingress of water and consequent damage to the unit,
always ensure that the cartridge cover is fully and properly inserted,
whether or not a Nav-Chart card is inserted.
➤
To insert a Nav-Chart card, refer to Figure 2-7:
1. Check that you are using the correct Nav-Chart card for the required
area.
2. Pull out the cartridge cover at the right hand side of the unit.
3. Hold the card with the title label and keyway slot towards you and the
two circular holes outermost, as shown below. Gently push the card
into its slot until it clicks into position. It will only fit in the correct ori-
entation.
4. To prevent the ingress of water, replace the cartridge cover.
or
www.navionics.it
to find the dealer nearest you.
2-9
Hide quick links:
Advertisement
Table of Contents
