Going To An Individual Target; Go To A Waypoint - Raymarine Chartplotter Owner's Handbook Manual

3-18

Going to an individual target

Rather than following a route, you can go directly to a selected target. This can
be an existing waypoint, a port or the current cursor position.

Go to a waypoint

To navigate directly to an existing waypoint:
ä
1. From the normal chart display either:
a) Use the trackpad to position the cursor over the required waypoint until
...then press ENTER to display the waypoint functions:
or b) press the GOTO key to display the waypoint options and select GOTO
128 nm
Alternatively, you can select the waypoint from the waypoint list as
described in section 3.2
2. Select GOTO WAYPOINT.
A dotted line is drawn between the vessel's current position and the
selected waypoint and navigation to the selected waypoint begins.
the waypoint options function is displayed:
WAYPOINT; the waypoint list appears. Use the cursor to select the
required waypoint:
WAYPOINT LIST
RayChart 420/420D Chartplotter
D4690_1